- Fits:
- KAWASAKI Z800 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI 750SS Mach IV (H2) 71-
There is no snagging, etc., and it works normally.I think that the quality of the bearing depends on the degree of low wear. I think it can be used without any problem as long as it rotates well and d...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
I'm still grateful that you are offering these parts as Ripro!Thanks for your help.Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Well, it's like this ….It's just right for Refresh for now!Read More - Fits:
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...and more.
I was disappointed because the design of the product was different from the picture, and the lock washer can only be used with OEM Type.After all, there is no Lock washer, so it is not yet ready to ru...Read More - Fits:
- KAWASAKI Z1000 MkII
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z1000 (air-cooled) A1
- KAWASAKI Z1000 (air-cooled) A2
- KAWASAKI Z750 (air-cooled) A4
- ...and more.
I just had those installed on my 1980 Kawasaki 1000MKII and love them. They feel great and have that retro pattern to them.Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
I have often used Tie Wrap, but I had to cut it off and use a new one every time, so I bought it. I am glad I bought it, even though it seems rather expensive.Read More - Fits:
- KAWASAKI Z1-R/Z1-RII 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- ...and more.
If you use it well, it will not leak oil as much as the OEM type rubber ones. if you degrease the BALI and apply the liquid gas well, and if you reuse it, you can use it almost permanently by removing...Read More - Fits:
- KAWASAKI Z1000 (air-cooled) KZ A1
- KAWASAKI Z1000 (air-cooled) KZ A2
- KAWASAKI Z750 (air-cooled) A4
- KAWASAKI Z750 (air-cooled) A5
- KAWASAKI Z750 (air-cooled) D1
- ...and more.
I tried to install it, but it was a simple installation with double-sided tape from the back, and I managed to install the left one, but it didn't fit tightly at all on the DOREMIRight SideSide cover.Read More - Fits:
- KAWASAKI Z900 (KZ900) 76-79
- KAWASAKI Z750 (air-cooled) 76-79
- KAWASAKI Z1000 (air-cooled) 76-79
In the paper Float Gasket, the Gasoline is just leaking and the Material is here.:I bought the Rubber Packing. The price is high, but the effect is very large.Read More - Fits:
- KAWASAKI Z900 (KZ900) 76-80
- KAWASAKI
- KAWASAKI Z750 (air-cooled) 76-80
- KAWASAKI Z1000 (air-cooled) 76-80
- KAWASAKI Z900 (KZ900) 76-80
- ...and more.
Electric wiring on older cars should be replaced as much as possible, including the 6V MONKEY/GORILLA Main Harness, Regulator, BatteryLEAD, Blinker harness, and Tail lamp.You never know when or where ...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Oil leak from Tachometer port is a common disease of air cooled Z.If it starts leaking, replace it with this one.The installation is a little hard, so apply more silicon grease and make sure to put it...Read More - Fits:
- KAWASAKI Z1000A 76-78
- KAWASAKI Z900 76-78
- KAWASAKI Z1 72-75
- KAWASAKI Z1R 1 Type
- KAWASAKI Z2 72-75
- ...and more.
I bought the Coil, Rotor, One way clutch and Rose because the price is not so different from the OEM type. The installation was easier than expected because there is a video of the installation on PMC...Read More - Fits:
- KAWASAKI Z1-R/Z1-RII 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- ...and more.
The Rear Sets and Kick pedal interfere with each other, so I removed the Kick pedal and installed this Cap.I like it because it matches the overall Image of the vehicle.It may not be suitable for a NO...Read More - Fits:
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z750FX
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI Z1000 MkII
- KAWASAKI Z1000
- ...and more.
There are not many used LTDOEMFender's available anymore.I think it is good to use it as it is if you can bear the texture of the plating.I couldn't stand it.Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Purchased with Washer.Only Gasket is difficult to prevent from deteriorating.It is a necessity when replacing parts.To be honest, it would be a big help if you could stock only Gaskets by Manufacturer...Read More - Fits:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z1-R/Z1-RII
- KAWASAKI Z1000
- KAWASAKI Z1000 MkII
- KAWASAKI Z2 (750RS/Z750FOUR)
- ...and more.
When reverting from Separate handle to STD Handlebar, the OEM Headlight BracketPurchased to re-install.If the cost was a little cheaper, I could be satisfied, but without this, the Light Bracket is ha...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
This Nut is well thought out. If it is an aggregate tube, it is possible to fasten it even if it is different Nut somehow, but it is impossible if it is a 4-pipe exhaust system, and this Nut becomes n...Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
Before attaching the Meter Wire to the Meter, you must run the Clamp through the Wire or you will have to start over.I've done it.Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
OEM Parts are still available. The price is not so different. What is the quality of Rubber?Which one shall we choose?Read More - Fits:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...and more.
OEM Parts are still available, so we recommend you to buy OEM Parts.Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING