- Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
[How is it used?HondaFTR223 (Past)KawasakiD Tracker (Past)KawasakiZ400 (Installed this time)Used in the above 3 car models.I have purchased three times because I personally felt the quality was good.F...Read More - Fits:
- SUZUKI DR-Z400S 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400S 00-09
It's so dark that you might think that the lights are not on when driving at night or when driving on the Tunnel. It is so dark. However, High beam is very bright. It is very useful for DRZ400sm which...Read More - Fits:
- SUZUKI DR-Z400S 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400S 00-09
I got this on my DR-Z400sm that was delivered today.According to the father of the shop where I bought it, the OEM didn't pass inspection, so they put it on with Service, and it's certainly bright.I r...Read More - Fits:
- SUZUKI DR-Z400S 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400S 00-09
OEMHeadlight's darkness is renowned as DR-Z's Achilles heel.Some Owner's replace the entire face, but this product eliminates the darkness without changing the OEM face.The amount of light of LED is a...Read More - Fits:
- SUZUKI DR-Z400S 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400SM 00-09
- SUZUKI DR-Z400S 00-09
OEMLight is too dark, so it costs a little, but I think it's worth it. In that sense, I think the cost is not bad. That's how dark OEM is.If you don't drive at night, you may not need this product, bu...Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
I installed a LEDICRelay made by MOTO LED and the Blinker did not respond.The other day, when I installed DRC's LED Fender Eliminator Kit, KITACO's Unbreakable lensMini Blinker on the front and rear o...Read More - Fits:
- Others Universal
- YAMAHA SEROW250
- YAMAHA SEROW225
- YAMAHA XG250 TRICKER XG250
- SUZUKI DR-Z400S
This is not a blinker made by DRC, but it is used as an universal bracket to install and fix the blinker I have. The tightening bolt holes are 8mm, which is the general size. The price is reasonable a...Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
I bought this to use on my WR250F, but I didn't read the instructions carefully and ended up not being able to use it ……It's a product I didn't have to buy because it worked fine without this ICRelay ...Read More - Fits:
- HONDA CB125 t
- HONDA CB125 gross domestic product
- HONDA CB125 Y
- HONDA CB250 k
- HONDA CBX125 CE
- ...and more.
I used it on my 79 CD125TZ. The installation and so on was not a problem, I was a little worried because the OEM was 35w compared to 6v 30w, but it came on properly. I was also satisfied with the brig...Read More - Fits:
- HONDA CB125 t
- HONDA CB125 gross domestic product
- HONDA CB125 Y
- HONDA CB250 k
- HONDA CBX125 CE
- ...and more.
The OEM Headlight has weakened to the point where it's almost invisible at night, which is dangerous I purchased this product because I felt that it was a good choiceIt's much brighter now that it's b...Read More - Fits:
- YAMAHA FZS1000 Feather Oil temperature gauge] [Installation position: oil pan drain bolt
- YAMAHA XJR400R 92-
- YAMAHA FZX750 -93
- YAMAHA FZR750 -88
- YAMAHA XJR400 92-
- ...and more.
Since YOSHIMURAMulti-temp meter was moved from another car model, Sensor Purchase onlyI installed it on my 750RS to control oil temperatureReplace it with the Crankcase Right Side blind screw, but If ...Read More - Fits:
- SUZUKI DR-Z400S 00-21
- SUZUKI DR-Z400SM 05-21
Flat on the front and uneven on the back to fit the shapeHowever, I'm not sure this is the caseIt's not impossible to put it on and it's about the same as other famous manufacturers, so that's goodonl...Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
After replacing the valve, it was not reacted by SW ON Yellow light upside down, front and back lit up. I think it's defective. And I turned it back on flasher status. Will you replace it?Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
CRF250L mugenSpec. Mounting on.For the company's LED Blinker back and forth installation, we replaced it.You can remove the RightShroud and access it, but it took time to install it. (Somehow inst...Read More - Fits:
- YAMAHA FZS1000 Feather Oil temperature gauge] [Installation position: oil pan drain bolt
- YAMAHA XJR400R 92-
- YAMAHA FZX750 -93
- YAMAHA FZR750 -88
- YAMAHA XJR400 92-
- ...and more.
Sensor for Progress seems to be different.I purchased a Sensor of this old type by mistake.When attaching to the car body and trying to connect with you, the Coupler does not fit (T_T)Everyone also li...Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
CRF250L (MD44) It installed in.Unlike MD 38, the installation location of Blinker relay is different, I thought that Wiring would be a little longer.Since it can not be mounted close to Injection, pro...Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
Mounting on KDX125SR.Since KDX 125 is 12 VDC after A 2, it is easy to make Blinker LED.Compared with other companies the price is cheap and easy to use.Since KDX employs a system in which front and re...Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
I purchased Blinker, Fender Eliminator and ICRelay.First I think that it will be High flasher with only Blinker and Fender Eliminator attached.Actually tried!I think that it is better to buy at the sa...Read More - Fits:
- HONDA CRM80
- HONDA XR230
- HONDA CRF230F
- YAMAHA WR250X
- YAMAHA WR250R
- ...and more.
Since Standard's Blinker was damaged, I exchanged it to Blinker of DRC, but in Relay of Standard, the High flasher phenomenon occurred, so I exchanged this Relay.After exchange, High flasher pheno...Read More - Fits:
- YAMAHA FZS1000 Feather Oil temperature gauge] [Installation position: oil pan drain bolt
- YAMAHA XJR400R 92-
- YAMAHA FZX750 -93
- YAMAHA FZR750 -88
- YAMAHA XJR400 92-
- ...and more.
There is no complaints about quality, but this red and no finish meets my own opportunitySince I have no choice, I paint it black and use itIt is very much appreciated if you allow us to select Anodiz...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING