(0)
(0)24 Reviews View type:
- Fits:
- YAMAHA SR500
- YAMAHA SR400
I bought it because I needed to replace the gasket when I overhauled the Manifold area.The paper quality is not bad and can be used just like OEM.good point● Easier to obtain than OEM.Durability is al...Read More - Fits:
- YAMAHA
The manufacturer's Negative Pressure Adapter to this product The installation is very easy because of the Bolt On However, when 1 pc of an attached bolt is tightened about halfway, it suddenly becomes...Read More - Fits:
- YAMAHA SR
I bought this product because the Idle Screw of the FCR Carburetor Body is difficult to useIt is easy to install and securely attached to the carburetorHowever, the Screw and the bottom screw of the F...Read More - Fits:
- YAMAHA SR500
- YAMAHA SR400
If you use the FCR Carburetor Body Carburetor as you bought it You can install the throttle wire and remove it by simply removing the lock nut You canWhen working on setting up Carburetor, the frequen...Read More - Fits:
- YAMAHA
I use the Assist system of Parts from Boa Ace's Parts, and to be honest, it works (Change) It seems that some of them have and some of them are getting worse One of the obvious changes is this Intake ...Read More - Fits:
- YAMAHA SR
Thanks to this product, I was able to install the CR without any troubleThe Instruction Manual is also very helpfulI use it with a negative pressure adapter and there is no problem at allRead More - Fits:
- YAMAHA SR
I bought it to install CR 38 of WM.I am satisfied that carburetor can be exchanged cleanly without interfering with FrameHowever, even if O-ring that sandwiches Manifold and Flange is too fat or Bolt ...Read More - Fits:
- YAMAHA SR
If there is enough skill to remove Normal cab, it will easily take youNegative pressure is explained to be connected to Fuel Cock, but I dared to connect to Air inductorSince there is no choice, Fuel ...Read More - Fits:
- YAMAHA
- YAMAHA
Until just before installation, there was a doubt - - -I was betrayed in a good way.Torque up. definitely.After all, Manufacturer doing seriously is different ~Number of boa Ace products handledI want...Read More - Fits:
- YAMAHA
- YAMAHA
No one notices it, but I really like it.I did mirror surface processing myself.The mixture became thinner than originally, but the amount of air is increasing by that amount.You can blow better than t...Read More - Fits:
- YAMAHA
- YAMAHA
If inclusion is satisfactory since the object for SR is foreseen and it is built, there are no worries about a Gasoline leak.
Read More - Fits:
- YAMAHA
- YAMAHA
It is dramatically good. After exchange, since an air-fuel mixture becomes thin, change of setting is needed in the direction of deep Sakka. if setting is decided -- Power -- it can blow and stage fri...Read More - Fits:
- YAMAHA
- YAMAHA
Parts that flow of the air-fuel mixture from a carburetor to an engine will be made into a smooth. It is the feature to carry out elliptic cutting of the admission port, and also it is aiming at the f...Read More
?
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING