Φ22.2mm handlebar 12V models only Grip Length: 120mm End-through type (Bar end can be attached) Grip inner diameter (right): Φ24.4mm (left): Φ21.2mm Grip O.D.: Φ33.6mm
*Please be aware that running at LEVEL 3 & 4 may result in battery failure or low temperature burns.Use for rapid heating. *The temperature graphs are measured indoors.Please refer to these values for reference. *If the throttle sleeve has any ribs, you will need to remove them.Even if the sleeve does not have a non-turning stopper, please cut down the sleeve according to the inner diameter of the grip. *Not compatible with FLAT throttle sleeve. *Make sure to use the special adhesive for Hot Grip (sold separately). *High temperature.Never touch with bare hands. *Doing so may result in low temperature burns and battery overload. *There may be changes in product specifications due to the manufacturer's reasons.
The switch is embedded in the grip and the grip diameter is almost as thin as stock. With "Quick Heat" function that warms up immediately upon switch-on. The resin inner liner and the film heater are used to prevent the temperature from escaping and to resist twisting, making it difficult to break the wire.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Recently viewed products
Ratings & reviews for this product or related products
[How is it used? From light riding to long distance touring Was the one you received as per Image? Street Image How was your experience with it? Large satisfied [Points to note] As long as you leave enough room for Wiring when you bend the Handlebar all the way, you should be fine. How did it compare to other products? Good because the Grip thickness is almost the same as OEM. Other items that would be helpful I would like to be able to purchase only the One Side Grip, but I would like the Gold amount to be lower.View Detail
I installed it for the winter. The price of OEM is too high, so I decided to use an external one. I have used KIJIMA for different motorcycles and this time I chose DAYTONA. The other reason why I chose DAYTONA is because the temperature is higher. It's good that the Switch is integrated, but it's hard to push when you're wearing Gloves, but it was easy not to have to attach the Switch separately.View Detail
Sorry about the pictures. I was working on one change and forgot to take a picture with the Griehee Single Body. You can see Grihi at the back of Han Cover.
[How is it used? It's very useful for commuting in winter.
Was the one you received as per Image? The size is so compact that you won't even notice it has a grip heater;
How was your experience with it? It's generally good.
[Points to note] The KIJIMA model can be activated with one click, but the DAYTONA model requires a long press. I didn't notice it at first and thought it was not energized! I was so quick to assume that it wasn't energized that I took the exterior apart again lol.
How did it compare to other products? Last year I was using a KIJIMA, but it was broken in the off-season and water got into it and it was broken. It becomes a replacement from there, but the first feature is its Smallness! It feels One sizeSmall, and the consideration which doesn't make Switch stand out can be felt. The only thing is that it's hard to press it when you're wearing a …Han Cover.
The warmth is about the same as the KIJIMA, but when I use the MAX temperature with my bare hands, it is too hot to grip. I think it is a nice problem in winter, but I want to use it with thin Inner Gloves.
It is the same evaluation as the one made by KIJIMA, but when I grip the Grip with my bare hand, the Edge hits and hurts. The grip is designed to be easy to grip even with thick gloves. However, it is hard to grip for NAKED HandRider who is not conscious. (It seems to be hard even with thin gloves like the ones worn by taxi drivers.View Detail
When I rode in a car with a Grip heater during the cold season, it was very comfortable, so I decided to install it in my own car as well.
You can adjust the warmth on four levels, but as long as you're riding at about 10 degrees outside, the Gloves for spring to fall are OK at their weakest. Knuckle guard and Quantity:If you set it, it may be OK in the middle of winter.
Installation is easy, but if you want to get it from the Attachment power supply under the Seat, it's too short for the STD, so I needed an extension.
The Switch is neat to look at because it has a built-in Grip, but on the other hand, it's hard to push when you're in Gloves, which makes it difficult for me to operate it while driving.
The Grip is not thicker than the OEM product and does not feel uncomfortable. It's hard to say how I would rate it in terms of design, because it varies from person to person, but I think it's a bit more.... If we're talking about costumes, the Switch separate type is cheaper, including other manufacturers, so I'll give it a deduction of 1 point.
However, I will use it conveniently as a necessity in the winter as there is no substitute for comfort. View Detail
The Grip heater is also new because I changed the car. The Grip heater has a Button inside the Grip, so the area around the handlebar is refreshed. It is not easy to push the button but you need to be careful when you are driving although you can push it when the car is stopped without any problem.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!