[Set components] ・Protective Film x 2set ・Cleaning accessory kit x 1set
[Components of Accessory Kit Set for Cleaning] ・Guide sticker ・Dust Absorber ・Wet Wipes ・Skeezy ・Cleaning cloth
*Long-term exposure to sunlight will accelerate the deterioration of the film. *The included cleaning accessory kit comes in one set. *The image may include other types and models. *There may be changes in product specifications due to the manufacturer's reasons.
* The image is only for reference. The image shown may differ from the actual product.
Clear glossy type protective film to protect from scratches and ultraviolet rays, and to prevent dirt and deterioration. It is easy to clean without damaging the main unit of the meter panel, even if it is covered with mud or dust. Hard type (PET) and soft type (TPU) are available according to the surface shape of the meter. Designed exclusively for models, cut to the shape of the meter panel. The film comes in two sets, so you don't have to worry about mistakes.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
I bought this product because I had a mysterious pin hole on the meter surface and it caused a crack. First of all, from a bad point, Scraper of paper is not usable from the moment it gets wet, and there was the harm of the scrap which peeled off adhering to the adhesive surface, etc. Included Parts:I think it is necessary up to here. GuideSeal and WetSeat etc. for installation and fixing are not necessary, and it is enough if there is a dust remover called Absorber and a MINIGlasses wipe. I'd like to do something about the Paper Scraper instead, and even though it comes with Included Parts:many and two spares, is it the inclusion of these that makes it a bit expensive? It is not difficult if it works like WindowFilm of the car etc. about installation or pasting. No initial positioning is required. How about the following installation method? ? Cleaning of the bonding surface, careful dusting with absorber Spray enough diluted detergent on the adhesive surface of the BodyFilm. (The position can be easily shifted and changed by spraying enough water) Bubble removal with hard RubberFilmScraper for Vehicle etc. ? Wipe up moisture etc. This will give you a finish almost as good as the Manufacturer's comment, and you probably won't need a spare. I think of it as a spare and store it for the future in case it deteriorates. The finish is not bad, and the hard film of for W800 was not difficult, although there is some difficulty in the three-dimensional curved surface. ~? There is some difficulty in 3D curved surface, but it can be managed by the above method. I think it is good for Ideas, the processing is accurate and beautiful, so the satisfaction after pasting is quite good. The protection performance and durability are unknown, but it is definitely more effective than the unprotected state where there is nothing. There is no useless reflection, and the transparency is the same as the state without sticking. It certainly looks better than the phone protection Film, I think it's not bad because it gives you the peace of mind that you're protected and it also prevents scratches.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!